Cam Chain Tension Adjuster - Suzuki DR-Z400S 2001 Service Manual

3-64 ENGINE

CAM CHAIN TENSION ADJUSTER

Install the cam chain tension adjuster. Pay special attention to
the following points:
Apply engine oil to the push rod.
Turn the adjusting screw clockwise with a flat-bladed screw-
driver until the push rod is locked.
Fit a new gasket to the chain tension adjuster body.
Use a new gasket to prevent oil leakage.
Install the cam chain tension adjuster body to the cylinder,
and then tighten the two Allen bolts to the specified torque.
Cam chain tension adjuster bolt:
Turn the adjusting screw counterclockwise with a flat-bladed
screwdriver to unlock.
Tighten the cam chain tensioner spring holder bolt to the speci-
fied torque.
Cam chain tensioner spring holder bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
8 N·m (0.8 kgf-m, 6.0 lb-ft)