Suzuki DR-Z400S 2001 Service Manual page 215

7-18 ELECTRICAL SYSTEM
TURN SIGNAL/SIDE STAND RELAY AND DIODE
The turn signal/side stand relay, which is located behind the
headlight bracket, is composed of the turn signal relay/side stand
relay and diode.
Remove the headlight assembly. (
Remove the turn signal/side stand relay.
Side stand relay
First, check the insulation between the D and E terminals us-
ing the multi circuit tester. Then, apply 12 V to terminals D and
C (+ to D and - to C) and check the continuity between ter-
minals D and E. If there is no continuity, replace the turn signal/
side stand relay with a new one.
09900-25008: Multi circuit tester set
Tester knob indication: Continuity test (
Diode Inspection
Measure the voltage between the terminals using the multi cir-
cuit tester. Refer to the following table.
C, B
A
09900-25008: Multi circuit tester set
Tester knob indication: Diode test (
NOTE:
If the multi circuit tester reads under 1.4 V, replace its battery
when the tester probes are not connected.
7-29)
+ Tester probe
C, B
1.4 – 1.5
0.4 – 0.6
)
)
Unit: V
A
Side stand relay
Diode
Turn
signal
relay