External Control; Expression Pedal Setup - Strymon cloudburst User Manual

External Control

Expression Pedal Setup

Use a TRS expression pedal to remotely control the knobs of cloudburst�
By default, cloudburst is configured so that an Expression pedal controls
the MIX knob�
1 Configure the EXP/MIDI jack for Expression Mode� (See
configuration instructions�)
2 Connect an expression pedal to the EXP/MIDI jack of cloudburst using
a TRS cable�
3 Press and hold the footswitch for at least 2 seconds, until the LED
blinks GREEN�
4
Rock your expression pedal to the HEEL position� The
will stop blinking and remain lit�
5 Set the knob(s) you would like to control to the desired settings for the
HEEL position of the expression pedal�
6 Rock the expression pedal to the TOE position� The LED will turn RED�
7 Set the knob(s) you would like to control to the desired settings for the
TOE position of the expression pedal�
8
Press and release the cloudburst footswitch to exit and store your
expression pedal setup�
NOTE: Your expression pedal assignment is saved per Favorite setting or
MIDI preset�
NOTE: If cloudburst is set to respond to MIDI EXPRESSION and the EXP/MIDI
jack is set to MIDI Mode, you can send MIDI CC# 100 with values 0 (heel) to
127 (toe) to perform the expression pedal setup�
page 11
RIGHT IN LEFT OUT RIGHT OUT
GREEN
for
USB
EXP
MIDI IN MIDI OUT
LED
pg 13