Table of Contents
Advertisement
Lex
- rotary
External Control
Expression Pedal Setup
Use a TRS expression pedal to control the knobs of Lex�
1
Configure the EXP/MIDI jack for Expression mode� See
configuration instructions�
2
Connect an expression pedal to the EXP/MIDI jack of Lex using a TRS
cable�
3
Press and hold both footswitches until both LEDs blink GREEN�
4
Rock the expression pedal to the HEEL position� Only the SLOW/FAST
LED will blink GREEN�
5
Set the knob(s) you would like to control to the desired settings for the
HEEL position of the expression pedal� Only the SLOW/FAST LED will
turn RED�
6
Rock the expression pedal to the TOE position� Only the ON LED will
blink GREEN�
7
Set the knob(s) you would like to control to the desired settings for the
TOE position of the expression pedal� Only the ON LED will turn RED�
8
Press either footswitch to exit and store your expression pedal setup�
NOTE: Your expression pedal assignment is saved per Favorite setting or per
preset�
NOTE: If Lex is set to respond to MIDI EXPRESSION and the EXP/MIDI jack is
set to MIDI mode, you can send MIDI CC# 100 with values 0 (heel) to 127 (toe)
to perform the expression pedal setup�
page 13
RIGHT IN
LEFT OUT
RIGHT OUT
for
USB
EXP
MIDI IN
MIDI OUT
pg 15
Advertisement
Table of Contents
