Table of Contents
Advertisement
SETTING UP
YOUR GATEWAY
2.0/
SETTING UP YOUR GATEWAY
There are three basic steps to setting up your Gateway:
Connect your Gateway to the Internet
Step 1:
Connect your network device to your Gateway
Step 2:
Configure your Gateway
Step 3:
Before you begin, if you are replacing an existing Gateway,
disconnect it. Remove all old Gateway components, including the
power supply. They will not work with your new Gateway.
STEP 1 - CONNECT YOUR GATEWAY
2.0a/
Remove your Gateway, Ethernet cables, and power
1.
adapter from the box.
Locate your high-speed Internet (WAN) outlet. This would
2.
be the wall jack installed previously by Verizon. Note the
type of jack may be either Ethernet or coaxial.
Connect your Gateway to the Internet (WAN).
3.
•
If connecting the WAN using Ethernet,
use the supplied white Ethernet cable and
plug one end into the white Ethernet WAN
port on the back of your Gateway. Plug the
other end of the cable into the high-speed
Ethernet wall jack.
Advertisement
Table of Contents
