Table of Contents
Advertisement
VIP X1600 M4S
4.3
Connections
Cameras
You can connect a maximum of four video sources to the module. Any cameras and other
video sources that produce a standard PAL or NTSC signal are suitable.
1.
2.
Audio Connections
The audio version of the VIP X1600 M4S module has two audio line inputs for a total of four
mono signals.
The audio signals are transmitted at the same time as the video signals. As a result, you can
connect a speaker or door intercom system at the destination point, for example. The
following specification should be complied with in all cases:
Impedance 9 kOhm typ., 5.5 V
The stereo plugs must be connected as follows:
Contact
Tip
Middle ring
Lower ring
Bosch Security Systems
Connect the cameras or other video sources to the BNC sockets Video In 1 to Video In 4
using a video cable (75 Ohm, BNC plug).
If the video signal is not looped through, termination is performed by a software setting if
necessary (see Section 5.17 Advanced Mode: Video Input, page 42).
Installation and Operating Manual
max. input voltage.
p-p
Audio In 1/2
Channel 1
Channel 2
Ground
Installation | en
Audio In 3/4
Channel 3
Channel 4
Ground
DOC | V4.0 | 2009.06
19
Advertisement
Table of Contents
