Table of Contents
Advertisement
VIP X1600 M4S
Malfunction
The module does not
report an alarm.
Control of cameras or
other units is not
possible.
The module is not
operational after a
firmware upload.
Placeholders with a red
cross are displayed
instead of the ActiveX
components.
Web browser contains
empty fields.
Bosch Security Systems
Possible causes
Alarm source is not selected.
No alarm response specified.
The cable connection between
the serial interface and the
connected unit is not correct.
The interface parameters do not
match those of the other unit
connected.
Power failure during
programming by firmware file.
Incorrect firmware file.
Sun JVM is not installed on the
computer or is not enabled.
Active proxy server in network.
Installation and Operating Manual
Appendix | en 105
Recommended solution
Select possible alarm sources on
the Alarm Inputs configuration
page.
Specify the desired alarm
response on the Alarm
Connections configuration page,
change the IP address if
necessary.
Check all cable connections and
ensure all plugs are properly
fitted.
Make sure that the settings of all
units involved are compatible.
Have the module checked by
Customer Service and replace if
necessary.
Enter the IP address of the
module followed by /main.htm
in your Web browser and repeat
the upload.
Install Sun JVM from the
product CD.
Create a rule in the local
computer's proxy settings to
exclude local IP addresses.
DOC | V4.0 | 2009.06
Advertisement
Table of Contents
