Bosch VIP X1600 M4S Installation And Operating Manual page 76

76 en | Configuration Using a Web Browser
NOTICE!
If you want to allow only secure connections with SSL encryption, you must select the Off
i
option for each of the parameters HTTP browser port, RCP+ port 1756 and Telnet support.
This deactivates all unsecured connections. Connections will then only be possible via the
HTTPS port.
You can activate and configure encryption of the media data (video, audio and metadata) on
the Encryption page (see Section 5.42 Advanced Mode: Encryption, page 83).
RCP+ port 1756
To exchange connection data, you can activate the unsecured RCP+ port 1756. If you want
connection data to be transmitted only when encrypted, select the Off option to deactivate
the port.
Telnet support
If you want to allow only secure connections with encrypted data transmission, you must
select the Off option to deactivate Telnet support. The unit will then no longer be accessible
using the Telnet protocol.
Interface mode ETH 1/ETH 2/ETH 3 (only for the module in Slot 1)
If required, select the Ethernet link type for the ETH 1, ETH 2 and ETH 3 interfaces on the
VIP X1600 XF. Depending on the unit connected, it may be necessary to select a special
operation type. These settings can only be configured for the module in Slot 1.
Network MSS (Byte)
You can set the maximum segment size for the IP packet's user data. This gives you the option
to adjust the size of the data packets to the network environment and to optimize data
transmission. Please comply with the MTU value of 1,514 bytes in UDP mode.
iSCSI MSS (Byte)
You can specify a higher MSS value for a connection to the iSCSI system than for the other
data traffic via the network. The potential value depends on the network structure. A higher
value is only useful if the iSCSI system is located in the same subnet as the VIP X1600 XF.
Enable DynDNS
DynDNS.org is a DNS hosting service that stores IP addresses in a database ready for use. It
allows you to select the module via the Internet using a host name, without having to know
the current IP address of the unit. You can enable this service here. To do this, you must have
an account with DynDNS.org and you must have registered the required host name for the
unit on that site.
NOTICE!
i
Information about the service, registration process and available host names can be found at
DynDNS.org.
Host name
Enter the host name registered on DynDNS.org for the module here.
User name
Enter the user name you registered at DynDNS.org here.
Password
Enter the password you registered at DynDNS.org here.
DOC | V4.0 | 2009.06 Installation and Operating Manual
VIP X1600 M4S
Bosch Security Systems