Advertisement
Position inspection and adjustment of Imprint-LED
J15415
LED lighting part
Inspection:
・ Fit the DATA between frames ADJ tool (J15415) to the pressure plate.
・ Push the tool toward the direction indicated by the arrow, and check that indications of the LED lighting part
is fit in the slit without vignetting.
* Check the slit by viewing from above under bright light source.
Adjustment:
・ Loosen the screw (#1590) and adjust the position of the LED lighting part by moving the adjustment groove
from side to side.
・ After the inspection, fix the position with the screw (#1590).
Standard:
・ The standard range regarding the distance between frames and data imprinting in images must be as follows:
Direction for Tool
7.1 mm
9.8 mm
0.09 mm
1.0 mm
- Ａ54 ･
13.8 mm
8.7 mm
8.2 mm
-
FAA41051-R.3644.A
#1590
Adjustment
groove
9.4 mm
Advertisement
