Advertisement
Sprocket
1583
#1583
Sprocket
533
#500
500
#46
46
Sprocket base unit
Back the sprocket base unit to the reset position
・ Turn the shaft A in the direction of the arrow so that the lever B is locked (fit) into the cam C.
Ref.: To release the lock, press the lever D in the direction indiecated by the arrow.
・ Keep the position of the screw hole of the shaft A so that the hole can be seen as shown below.
(The hole comes to the below position once in 3 turns.)
Grease: G92KA
Apply slightly to the tip of the
lever D and the groove between
two-pronged part under the lever.
Lever D
Screw hole
Lever B
- Ａ23 ･
-
・ Position the notch of the sprocket (#533)
as shown above.
Sprocket base unit
Cam C
Shaft A
FAA41051-R.3644.A
Advertisement
