Nikon F6 Repair Manual page 78

Hide thumbs Also See for F6:

Procedure for Inspection/Adjustment

① Start the adjustment software (J18375). Select "CCD ALIGNMENT INSPECTION AND ADJUSTMENT"

from the "INSPECTION AND ADJUSTMENT FOR AE CCD POSITION", and make inspections and

adjustment by following the instructions shown on the PC.

　 Note: When measuring, darken the AE CCD unit by covering it with a black cloth, etc.

direction

② Select "SLANT INSPECTION", and check the slant of the AE CCD.

・ This works only for the inspection, not for the adjustment.

In case the result is out of standard, perform "CCD ALIGNMENT INSPECTION AND ADJUSTMENT" again.

However, if it is still out of standard, replace the penta-FPC unit.

③ After the adjustment and inspction/adjustment, fix 3 screws with Screw lock (EDB0011).

　＊ Note: If the adjustment is made, make the inspection again after mounting the top cover.

・ Turn the screw of "X" or "Y", and make an adjustment until the

indication on PC falls under the standard.

・ "Z" screw is the reference screw, so it is better not to turn it.

However, if there is no alternative, turn it for the adjustment.

AE CCD output

X direction

- Ａ35 ･

FAA41051-R.3644.A

41051faa