Advertisement
Caution
When disassembling/(re)assembling, be sure to use the conductive mat (J5033) and wrist strap (J5033-5)
①
for static protection of electrical parts.
When disassembling, make sure to memorize the processing state of wires and FPC, screws to be fixed and
②
their types, etc.
In the chapter of Disassembly, sometimes a large assembly unit is removed. In case such a unit is further
③
disassembled , refer to the Parts List.
Refer to the Parts List regarding the drip-proof sponge, which is not described in Disassembly/
④
(re)assembly chapters.
When disassembling and/or (re)assembling, be sure to remove batteries
⑤
Points to notice for Lead-free solder products
・ Lead-free solder is used for this product.
・ For soldering work, the special solder and soldering iron are required。
・ Do NOT mix up lead-free solder with traditional solder.
Disassembly
1. Separate Front body from Rear body
External rubber
#63
� ��
- Ｄ1 ･
-
FAA41051-R.3644.A
.
・ Removing #42 is NOT necessary,
unless it should be replaced.
#42
��
#B61
� ��
#63
��
Advertisement
