Advertisement
Mount S.I. (Super Impose) unit
#1577×2
S.I. unit
Penta-FPC
A part
Mount Prism box unit on Front body
・ Attach 2 parallax adjustment spacers (#1182) on the
prism box with 2 pieces of the both-sided adhesive
tape (#1184)
① Be sure to put 0.6-mm spacer on the A side. If not,
put it without fail.
② When the prism box is replaced, be sure to attach
the 0.4-mm spacer on the B side.
（ The spacer is for a coarse adjustment of parallax.
When the prism box unit is removed, be sure to
make a fi ne adjustment after assemble the body.
Refer to "Adjustment of parallax".
・ Put the alignment adjustment washers (#1180 and
#1181).
・ Mount the prism box unit by pressing it lightly in the
oblique direction of the arrow towards the bayonet
and preview sides for positioning.
・ Fix the prism box unit with 4 screws (#1188).
A part
・ Mount the S.I. unit, and fi x it with 2 screws (#1577).
・ Attach the soldering-bridge part of the penta-FPC to the A
part of the S.I.unit, and solder them.
※ ① Inner LCDs (Bottom/Horizontal-display LCDs) :
In case vignetting is caused on indications, adjust the position
of mounting the S.I.unit. (Connect the top cover and body with
the relay-FPC A.)
- Ａ12 ･
Soldering bridge
When the inner-LCDs are disassembled, make an
inspection/adjustment of lighting by referring to "How
to connect relay-FPC" of Adjustment section.
② When the S.I. unit is disassembled, check lighting before
the top cover is attached.
#1182C
A-side
#1184×2
Direction for
positioning
#1180
- -
FAA41051-R.3644.A
B-side
#1182A
#1188×4
#1181
Advertisement
