Advertisement
15.3 Clock Settings
15.3.1 T16B Operating Clock
When using T16B Ch.n, the T16B Ch.n operating clock CLK_T16Bn must be supplied to T16B Ch.n from the
clock generator. The CLK_T16Bn supply should be controlled as in the procedure shown below.
1. Enable the clock source in the clock generator if it is stopped (refer to "Clock Generator" in the "Power Supply,
Reset, and Clocks" chapter).
When an external clock is used, select the EXCLnm pin function (refer to the "I/O Ports" chapter).
2. Set the following T16BnCLK register bits:
- T16BnCLK.CLKSRC[2:0] bits (Clock source selection)
- T16BnCLK.CLKDIV[3:0] bits (Clock division ratio selection = Clock frequency setting)
15.3.2 Clock Supply in SLEEP Mode
When using T16B during SLEEP mode, the T16B operating clock CLK_T16Bn must be configured so that it will
keep supplying by writing 0 to the CLGOSC.xxxxSLPC bit for the CLK_T16Bn clock source.
If the CLGOSC.xxxxSLPC bit for the CLK_T16Bn clock source is 1, the CLK_T16Bn clock source is deacti-
vated during SLEEP mode and T16B stops with the register settings and counter value maintained at those before
entering SLEEP mode. After the CPU returns to normal mode, CLK_T16Bn is supplied and the T16B operation
resumes.
15.3.3 Clock Supply in DEBUG Mode
The CLK_T16Bn supply during DEBUG mode should be controlled using the T16BnCLK.DBRUN bit.
The CLK_T16Bn supply to T16B Ch.n is suspended when the CPU enters DEBUG mode if the T16BnCLK.DB-
RUN bit = 0. After the CPU returns to normal mode, the CLK_T16Bn supply resumes. Although T16B Ch.n stops
operating when the CLK_T16Bn supply is suspended, the counter and registers retain the status before DEBUG
mode was entered. If the T16BnCLK.DBRUN bit = 1, the CLK_T16Bn supply is not suspended and T16B Ch.n
will keep operating in DEBUG mode.
15.3.4 Event Counter Clock
When EXCLnm is selected as the clock source using the T16BnCLK.CLKSRC[2:0] bits, the channel functions as a
timer or event counter that counts the EXCLnm pin input clocks.
The counter counts rising edges of the input signal. This can be changed so that the counter will count falling edges
of the original signal by selecting EXCLnm inverted input as the clock source.
EXCLnm inverted input
Note: When running the counter using the event counter clock, two dummy clocks must be input be-
fore the first counting up/down can be performed.
S1C17W15 TECHNICAL MANUAL
(Rev. 1.3)
EXCLnm input
Counter
x
Counter
x
Figure 15.3.4.1 Count Timing (During Count Up Operation)
Seiko Epson Corporation
x + 1
x + 2
x + 1
x + 2
15 16-BIT PWM TIMERS (T16B)
x + 3
x + 3
15-3
Advertisement
