Unipulse F805AT-CK Operation Manual page 28

4) The FINAL screen appears.
Check the code No. at the upper part, and then
input a desired FINAL value with the numeric
keypad, and register it with
Notice
Select a Code number by pressing
method; then select a Code number via Control I/O on the rear panel called "External
input".
All setting items from FINAL to COUNT LIMIT (a) correspond to "Setting Code" on the
screen of Setting Each Code.
While performing Setting Code Selection through External input, it can only be set (a)
on Code No. selected by external input because External input is prior to Key input in
this situation.
To the contrary while performing Key input of Setting Code Selection it only enables to
set (a) on Code No. selected through Key input because Key input is prior to External
input.
When Setting (a), check the Code No. on the Setting screen before starting the
operation.
3.SCREEN COMPOSITION AND SETTINGS
FINAL
.
ＯＫ
key, as described in 3) called "Key input"
－
＋
Code No.of Setting final value
for registration
17