Each Code Key Disablement; Accumulation Command Acceptance; Tare Display - Unipulse F805AT-CK Operation Manual

6-2-7. Each code key disablement

F805AT-CK enables to disable Each Code key (Final, Over, Under, ACCUM.CLEAR, TOTAL COMP,
TOTAL LIMIT, COUNT LIMIT) for avoiding false operation on the touch screen.
If this setting is INVALID, writing of set values through RS-232C is also disabled.
Select VALID or INVALID in the Function setting item
1) VALID Changing of set values of each code is enabled.
2) INVALID Changing of set values of each code is disabled.
Operation
MODE FUNCTION
Press
→
Select INVALID/ VALID

6-2-8. Accumulation command acceptance

Select to receive the accumulation command regularly (REGULARLY) or to receive it only when the
indicated value is stable (IN STABLE MODE). Select from REGULARLY/ IN STABLE MODE.
1) REGULARLY
2) IN STABLE MODE
Operation
Press MODE EXTENDED FUNC.
→
Select REGULARLY/ IN STABLE MODE

6-2-9. Tare display

The tare can be displayed on the main display by keeping TARE pressed with the setting of TARE
KEY ON.
Select from TARE KEY ON/ INHIBIT.
1) TARE KEY ON
2) INHIBIT
Operation
Press MODE EXTENDED FUNC.
→
Select INHIBIT/ TARE KEY ON
PAGE EACH CODE KEY
→ →
OK
→
The accumulation command is accepted regularly.
The accumulation command is accepted only when the indicated value is
stable (while the STAB lamp is lit).
ACCUMULATION COMMAND ACCEPTANCE →
→
The tare is displayed when
The tare is not displayed.
TARE DISPLAY →
→
OK
→
6.FUNCTION SETTING
→
OK
→
is kept pressed.
TARE
45