Table of Contents
Advertisement
SL-XP865G-3IG
2-10.2 JBAT1: Clear CMOS
When you have problem with rebooting your system, you can clear
CMOS data and restore it to default value. To clear CMOS with Jumper
JBAT1, please follow the steps below:
1. Power off system.
2. Set JBAT1 to Pin 2-3 closed.
3. After 2 or 3 seconds, restore the JBAT1
setting to Pin1-2 closed.
4. CMOS data are restored to default now.
Remember never clear
CMOS when system power is on.
2-10.3 JPIN1-JPIN6: RS-232/422/485 selection for COM2
JPIN1 to JPIN6 are designed to select RS232/RS422/RS485 interface
for serial connector COM2 setup.
JPIN1-JPIN6
Jumpers Settings
for RS-232
(default)
Jumpers settings
for RS-422
Jumpers settings
for RS-485
2-10.4 JKB1: Keyboard/Mouse Wake Up
Jumper JKB1 is designed on board to en-
able or disable the PS/2 Keyboard/Mouse
wake-up from suspend mode function.
(USB device Wake-up function is optionally
built in. If USB Wake-up function is chosen
by users, it should be first enabled vy BIOS
setup. See ACPI Configuration in BIOS
Setup.)
JPIN1-JPIN6
RS-232/422/485 selection for COM2
3
1
1-2 1-2
1-2
2-3
2-3
2-3
2-3
30
JBAT1
Clear CMOS
1-2 closed
To hold data
1
To clear CMOS
1
3
1
1-2 1-2
1-2
2-3
2-3
2-3
1-2
2-3
2-3
2-3
2-3
JKB1:
Keyboard / Mouse
Wake Up
1-2 closed (default)
Disabled
1
2-3 closed
Enabled
1
(default)
2-3 closed
Advertisement
Table of Contents
