Chapter 2 Operating The Src-101 (Manual Operation); Basic Operation - OptoSigma SRC-101 Instruction Manual

Remote controller for sgdc actuators
Table of Contents

Advertisement

③STOP LED
(4) JOG switch
(5) Fine movement knob
(6) USB connector
(7) Motor connector
(8) Power supply terminal
(9) Power switch

Chapter 2 Operating the SRC-101 (Manual Operation)

4. SRC-101 Connection Procedure
4-1. Connect the SRC-101 and the remote actuator
(1) Make sure that the power is not turned on to this device.
(2) Connect the actuator to the motor connector of this device.
4-2. Connect the SRC-101 to the AC adapter Connect
the dedicated
AC adapter to this unit.
(1) Make sure that the power is not turned on to this device.
(2) Connect the AC adapter to the power terminal of this unit.
4-3. Powering on
Turn the power switch on the ON side and turn on the power to this device.
The front panel RUN and STOP LEDs
simultaneously after approximately 1
,
* If the LED does not light up
When connecting various cables, be sure to connect with
caution

5. Basic operation

This device can easily operate the actuator by manually operating the switches and knobs on the front panel. The basic
operation method is described below.
3210 S
C
W
, S
OUTH
RODDY
AY
When an alarm is detected, the red LED lights up or blinks to indicate an abnormality.
See
page
See 6.
Alarms (
The actuator can be operated at a constant speed (jog operation).
This knob allows you to operate the actuator like a micrometer.
It is used when controlling by serial communication.
* DX2R005HN2 (equivalent to Japan JAE Industries, Ltd.)
Connect a compatible remote actuator or MDC cable. The connector is lockable, so
do not pull the cable forcibly when inserting and removing.
dedicated
Connect the
AC adapter. Do not use anything other than accessories.
Turn on the ON side to turn on the power. Turn off the power when it is turned
off.
to this device and the actuator to be used.
illuminate simultaneously when power is applied and
second
.
check the connection of the AC
6
O
S
C
PTO
IGMA
ORPORATION
A
, C
92704 USA, TEL. 949-851-5881, E-
ANTA
NA
ALIFORNIA
8).
adapter
.
the power
turned off.
MAIL SALES
turn off
@
.
OPTOSIGMA
COM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SRC-101 and is the answer not in the manual?

Table of Contents