Front Control Panel - Supermicro C9Z690-CG User Manual

Super C9Z690-CG/-CGW User's Manual

2.7 Front Control Panel

JF1 contains header pins for various buttons and indicators that are normally located on a
control panel at the front of the chassis. These connectors are designed specifically for use
with Supermicro chassis. Refer to the figure below for the descriptions of the front control
panel buttons and LED indicators.
Note: You may connect the JF1 using the S-Connector comes with the motherboard.
The S-Connector is a plug designed to connect the front control panel header on the
motherboard and front control panel cables of chassis. Please align the printed
indications on the S-Connector with the corresponding pins on JF1 when plugging in.
Refer to the checklist table in Section 1.1 and contact Supermicro for more detailed
connector information.
MAC CODE
SP1
B1
USB4/5
JSTBY1
JLED_POGO2
CPU LED
DIMM LED
VGA LED
BOOT LED
JL1
JLED1
JF1
MAC CODE BAR CODE
22110
22110
JLED_POGO1
2280
2280
2280
2260
2260
BIOS
LICENSE
2260
LED2
LED4801
PCIE M.2-M2
PCIE M.2-M3
LED3
PCIE M.2-M1
PCH
LED4
JWD1
LED1
JSD1 I-SATA0 I-SATA2 I-SATA4
I-SATA1 I-SATA3 I-SATA5
15
POWER LED (-)
HDD LED (-)
NIC1 LED (-)
NIC2 LED (-)
Overheat/
Fan Fail LED (-)
X
Ground
Ground
1
SW1
HD AUDIO
LAN2 LAN1
USB8 (3.2, 10Gb) USB6 (3.2, 10Gb)
USB9 (3.2, 20Gb) USB7 (3.2, 20Gb)
JRLED1
LED18
LED17
SYS_FAN3
C9Z690-CGW
DIMMA1
REV:1.00
DIMMA2
DIMMB1
DIMMB2 DESIGNED IN USA
USB12 (3.2, 20Gb) JPW1
SYS_FAN1
SYS_FAN2
16
POWER LED (+)
HDD LED (+)
NIC1 LED (+)
NIC2 LED (+)
Overheat/
Fan Fail LED (+)
X
Reset Reset Button
PWR Power Button
2
42
DP/HDMI
USB0/1/2/3
CPU_FAN2
JPW2
RESET
POWER
BUTTON
BUTTON
CPU_FAN1 CLEAR CMOS
12V_PUMP_PWR1