Activating The Battery - Siemens SIPROTEC 5 V9.30 Manual

Table of Contents

Advertisement

NOTE
i
i
The installation depth for 1 device is at least 275 mm (11.83 in). This dimension includes the necessary
bending radius for the various connectors of the plug-in modules.
The M4 holes are the holes for the fastening screws of the device. The Ø 6 holes are the openings for the
fastening screws of the on-site operation panels on the device.
NOTE
i
i
Use a PZ2-size Phillips screwdriver.
For each module, you need 4 fastening screws with a shank diameter of 4 mm (0.16 in)
!
WARNING
Danger due to device being improperly screw-fastened
Incomplete and careless screw-fastening can lead to death, severe injury, and considerable material
damage.
Ensure that screw-fastening is complete at all intended bolting points. Tighten the screws to a torque
²
of 1.2 Nm.
If no assembly opening is prepared, then cut out the required assembly opening.
²
Produce the holes as shown in the drilling plan.
²
Fitting the Devices
Detach the top and bottom plastic screw covers of each on-site operation panel.
²
Insert the device in the installation opening. Make sure that the fastening screws of the on-site operation
²
panels also protrude exactly into the openings (6-mm diameter (0.24-in diameter)).
With the M4 oval head cap screws, bolt down the device at the top and bottom at all 4 bolting points of
²
each module.
Check for secure attachment.
²
Fit the top and bottom plastic screw covers again.
²

Activating the Battery

3.1.2
Remove the protective film
NOTE
i
i
The battery is covered with a protective film to protect it from mechanical damage and against premature
discharge.
The battery need not be removed from the battery compartment for activation.
NOTE
i
i
Only use an insulated tool for opening and closing the battery cover, as well as for removing and inserting
the battery.
Pull out the battery compartment.
²
Remove the protective film from the battery by simply pulling on the film tab.
²
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-J, Edition 07.2022
Fitting the Devices
3.1 Flush-Mounting Devices
47

Advertisement

Table of Contents
loading

Table of Contents