Displaying Fault Records - Siemens SIPROTEC 5 V9.30 Manual

Operation in the Operating State
8.7 Fault Recording
NOTE
i
i
•
Take note that when accessing via online access points the fault records read replace all fault records
previously shown in the window. If you wish to save special fault records, then export the fault
records (see chapter
•
When accessing via a device created in the project, older fault records no longer in the device remain
kept. If you wish to delete no longer needed fault records, read chapter
the Logs).
[scaslstr-080413-01.tif, 1, en_US]
Figure 8-41

Displaying Fault Records

8.7.3
Procedure
•
To be able to display and analyze a fault record, you must open the fault record of your choice in the list
of read fault records by double-clicking.
After opening, the fault record is automatically displayed on the COMTRADE Viewer. You can select between
primary and secondary values. If you wish to do expanded analyses of fault records using the options of the
COMTRADE viewer, you can optionally press the Open record with SIGRA button to start the analytical soft-
ware SIGRA. You must have the analytical software SIGRA installed on your PC.
202
8.5.13 Saving and Deleting the
Reading Fault Records with DIGSI 5
Logs).
8.5.13 Saving and Deleting
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-J, Edition 07.2022