Table of Contents
Advertisement
5.3
Displays for Indication and Control
Displays
Displays for indication and control offer you the possibility of quickly obtaining an overview of important oper-
ating modes. You can configure a total of up to 10 displays in DIGSI 5 using the Display Editor. The following
contents are available here:
•
Dynamically updated measured values
•
Status of indications
•
Switch positions of switching objects
•
Texts
•
Graphical elements
NOTE
i
i
The displays and controls are displays created in DIGSI 5.
Default Displays
In the idle state, that is, provided there is no fault, the display with DIGSI 5 can show configurable operating
information (for example, operational measured values). If preconfigured in DIGSI 5, display images can be
suppressed by spontaneous displays in the event of a fault.
A device ready for operation will show you the following display image after booting. This presupposes you
have not parameterized a display image with DIGSI 5. The standard display image (default display) is parame-
terized and defined in DIGSI 5. If a parameterized and defined display image exists, it is displayed after
booting.
[scligrdi-080413-01.tif, 1, en_US]
Figure 5-6
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-J, Edition 07.2022
Standard Display Diagram for SIPROTEC 5
Using On-Site Operation Panel
5.3 Displays for Indication and Control
91
Advertisement
Table of Contents
