Table of Contents
Advertisement
Operation in the Operating State
8.3 Operation Options
You can now establish a connection to the devices.
[scwalger-090718, 1, en_US]
Figure 8-2
Under Online access → Interface, open the desired device (a).
²
The basic information is displayed below the device.
You can find the following tabs in the menu item Device Information:
•
Device information
•
Resource consumption
•
Log for device diagnosis and security
•
Time Information
•
Diagnostic information
Click Refresh device data to read the parameter set and the process data of the device. The device data
²
is loaded and the view completed.
You can fully operate and set the connected devices under Online access in the DIGSI 5 project tree.
Adding a Selected Device to a Project
You can accept devices identified online into an existing project. The devices are also available for possible
offline operation. You can take over the devices in 2 different ways:
Use Drag & Drop to assign the online device to the corresponding device created in a project.
²
NOTE
i
i
Make sure that the created device corresponds to the device identified online. Otherwise, it is not taken
over into the project.
If you have not done so yet, add the online device to the opened project (see following figure) via the
²
context menu (right mouse click).
158
Device Identification via the DIGSI 5 Project Tree
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-J, Edition 07.2022
Advertisement
Table of Contents
