Table of Contents
Advertisement
Maintenance, On-the-Spot Assistance and Test
10.4 Update Firmware and Configuration
[scfwdvlo-280716-01, 1, en_US]
Figure 10-14
After the firmware update of the device and the communication modules, all firmware components of the
device have been updated.
You can find more information on this in
Special Features when Handling Protocols
10.4.3
The firmware for the communication modules consists of the basic firmware and all available protocols. The
communication drivers depend on the device firmware and must be updated together with this firmware.
When you set parameters for a protocol in DIGSI 5 and when you load the configuration into the device, the
protocol firmware is loaded automatically in the device if necessary.
Upgrading Project Devices
10.4.4
To be able to use the extended functionality after a firmware update, you must perform an upgrade of the
project devices. Proceed as follows:
NOTE
i
i
Before doing an update, back up the configuration of your SIPROTEC 5 device using DIGSI 5 via Connect
device and retrieve data!
•
Start DIGSI 5 on your PC.
•
In the project tree, select Upgrade project devices.
[scupgpar-041016-01, 3, en_US]
Figure 10-15
270
Status of Firmware Update
Structure of the HW/SW Information Menu Item, Page
Menu Item in the Project Tree
257.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-J, Edition 07.2022
Advertisement
Table of Contents
