Initializing A Device - Siemens SIPROTEC 5 V9.30 Manual

Using DIGSI 5

6.3 Initializing a Device

6.3 Initializing a Device
NOTE
i
i
Initialization is possible, for example, via the USB interface or port J of the device.
NOTE
i
i
The physical connection between PC and SIPROTEC 5 device may be done only 1 to 1. If your PC has several
free USB interfaces, you can connect only one single SIPROTEC 5 device. Otherwise, no connection to the
devices is established. If you set up a hub between PC and the SIPROTEC 5 devices, no connection to the
devices is established either.
Connect the top USB port on the front panel of the on-site operation panel of the base module of SIPROTEC 5
devices to the engineering PC using a suitable USB cable. If you have connected the protection device to your
PC, you can initialize the device with the help of DIGSI 5.
•
Select the relevant offline configuration in a DIGSI 5 project by selecting the device name.
•
Open the context menu by right-clicking.
•
Select Initialize Device.
•
The offline configuration is thereby transferred to the device and the offline configuration in the DIGSI 5
project connected via the serial number of the device.
Check whether there is a connection between your DIGSI 5 project and your device. If you wish to compare
the serial number in the editor and the device information with the label of the device, proceed as follows:
Double-click in the project tree the Device information tab under the device. You will find the serial
²
number in the General section.
112 SIPROTEC 5, Operation, Manual
C53000-G5040-C003-J, Edition 07.2022