Device-Diagnosis Log - Siemens SIPROTEC 5 V9.30 Manual

Operation in the Operating State
8.5 Logs
NOTE
i
i
•
The logged indications are preconfigured and cannot be changed!
•
This log, which is organized as a ring buffer, cannot be deleted by the user!
•
If you want to archive security-relevant information of the device without loss of information, you
must regularly read this log.

Device-Diagnosis Log

8.5.9
Concrete take-action instructions are logged and displayed in the device-diagnosis log for the following items:
•
Required maintenance (for example, battery supervision)
•
Identified hardware defects
•
Compatibility problems
Up to 500 indications can be stored in the device-diagnosis log. In normal operation of the device, it is suffi-
cient for diagnostic purposes to follow the entries of the operational log. This specific significance is assumed
by the device-diagnosis log when the device is no longer ready for operation due to hardware defect or
compatibility problems and the fallback system is active.
Reading from the PC with DIGSI 5 in Normal Operation
•
To reach the device-diagnosis log of your SIPROTEC 5 device, use the project-tree window.
Project → Online access → Device → Device information → Logs tab → Device-diagnosis log
The status of the device-diagnosis log last loaded from the device is shown to you.
•
Before this, refresh the contents by clicking the update arrows in the headline.
[sc_devdia, 1, en_US]
Figure 8-29
Reading on the Device through the On-Site Operation Panel in Normal Operation
•
To reach the diagnosis log from the main menu, use the navigation keys of the on-site operation panel.
Main Menu → Test & Diagnosis → Logs → Device diagnosis
•
You can navigate on the on-site operation panel using the navigation keys (top/bottom) inside the
displayed indication list.
186
Reading the Device-Diagnosis Log with DIGSI 5
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-J, Edition 07.2022