Post-Print Routines; Post-Print Guide - 3D Systems wematter Gravity User Manual

Table of Contents

POST-PRINT ROUTINES

1. Remove your 3D prints

2. Clean the build chamber

Note: The vacuum used in this procedure must be approved for the collection of combustible dust. A

portable vacuum listed for Class 2 Division II locations is recommended.

3. Power health check

4. Refill the machine with powder

Note: 3D Systems provides instructions to advise skilled and non-skilled persons in installing, operating, and

maintaining the Gravity. The Gravity shall only be maintained by a qualified and trained person.

CAUTION: Unauthorized disassembly or repair procedures may damage the printer, void the warranty, and be

dangerous.

: Wear personal protective equipment when performing maintenance tasks.

CAUTION: Use tools only as described.

CAUTION: Failure to follow these routines may cause machine failure or lowered 3D print quality.

Note: Fugitive combustible dust inside, outside and around the machine, in quantities that obscure the color

of the surface shall first be collected by gently brushing and manually removing the accumulations, followed

by vacuuming any residual dust. Light accumulations are permitted to be removed by vacuuming.

Note: The vacuum cleaner shall be certified for the collection of the combustible dust involved.

Note: For non-metal dust, wiping down all surfaces with a dry cloth, then wiping all surfaces down with a

damp cloth, and finally again wiping all surfaces with a dry cloth is permitted.

The Gravity Machine will guide the user through the Post Print Routine using the built-in touchscreen.

It is recommended to read the routine below carefully on first use and use the guide as a reminder for future use.

3D Systems, Inc.

p/n 74-D001, Rev. A

Table of Contents