Table of Contents
Advertisement
Powder Refill Mode - Red Light
When the hatch is ready to be opened the machine is indicating that with a light red tone.
The user can refill powder in this mode.
Cleaning Mode - Cold White Light
The printer has its power on but no heaters are heating, no motors are running but there is light.
The interaction is almost entirely inside the machine.
Refill is allowed.
The mode exits when the user confirms that everything is ready for printing or standby mode.
7.1 Various Modes
The machine could be set in the following modes:
•
Preparing - Warm Yellow
•
Print - Pulsing White
•
Cooldown - Blue
•
Finished - Green
•
Cleaning - Cold White
•
Ready - Warm White
•
Aborting - Pulsing Red
•
Aborted - Red
•
Error - Pulsing Red and Yellow
•
Powder Refill Needed - Yellow
•
Powder Refill Mode - Red
Preheat and Print
The machine is heated during "preparing" and "print". Be aware that temperatures inside the machine and the door are
elevated and avoid contact with these areas.
Cooldown
The machine is heated during "preparing" and "print". Be aware that temperatures inside the machine and the door are
elevated and avoid contact with these areas.
3D Systems, Inc.
22
p/n 74-D001, Rev. A
Advertisement
Table of Contents
