Table of Contents
Advertisement
Finished - Cleaning
The machine is ready to be handled by an operator. Parts of the machine can still be hot so the operator should take extra care
when evacuating and interacting with the machine.
The door can be opened by clicking "Door".
This will unlock the door and bring the machine into "cleaning".
When the machine has been prepared for the next print job click "Clear". The machine will then "Ready".
CAUTION: The door needs to be closed to be able to "clear".
Ready
After clicking "Clear" the machine will enter Ready. It is now only possible to calibrate power, start a print, or refill. It is not
possible to open the door when the machine has entered the state "Ready".
CAUTION: The door needs to be closed to be able to "clear".
Refill
In the refill state, it is possible to fill up the machine with more powder. This is also the state for filter cleaning through the refill
hatch which must be done after every refill and after every print job.
Error
Contact 3D Systems as soon as possible and do not turn off the machine.
3D Systems, Inc.
23
p/n 74-D001, Rev. A
Advertisement
Table of Contents
