Table of Contents
Advertisement
TOPIC
Housecleaning and
prevention of accumulation
of explosive dust
concentrations
Material Exposure
Specific Materials
Material Handling Precautions
During normal operation of the Gravity using 3D Systems' materials, you are not required to wear a dust mask or special
personal protection equipment unless specifically designated. Check the SDS of the material used for the specific precautions
you should observe. Use the following table of precautions as a general guide:
Safe Material Handling Guidelines
CATEGORY
Fire/Heat
Inhalation
Shop Safety
Avoiding Spills
3D Systems, Inc.
REFERENCE/CONTACT
US: NFPA 654: Standard for the Prevention of Dust Explosions in the Plastics Industry;
National Fire Protection Association, Volume 5 of the National Fire Codes
Europe: Maximale Arbeitsplatz Konzentration, January 1990
US: Code of Federal Regulations, 29 CFR, section 1900.1000, available from Superintendent of
Documents, Government Printing Office, Washington, D.C. 20402
Europe: DIN EN 26184 Teil 1 /06.91
Material Safety Data Sheets (MSDS) from 3D Systems, Inc.
US/Canada:
Mfgr. Contact:
Information
Emergency
3D Systems Corporation 333
Three D Systems Circle Rock
Hill, SC 29730 USA
Phone: 803.326.3900 or Toll-
free: 800.739.3669
1.800.262.8200 - Chemtrec
PRECAUTION
•
Never smoke or ignite anything around powdered
materials.
•
Maintain proper clearance from materials when using
portable heating devices.
•
Store flammable liquids away from materials.
•
After removing a part from the print chamber, allow it to
cool to room temperature in a well-ventilated area.
•
Use anti-static mats in front of SLS equipment.
•
Avoid breathing powdered materials, when exposure to
dust or fumes is likely, wear a NIOSH- approved respirator
appropriate to the airborne concentration.
•
Always provide adequate ventilation.
•
Train operators in SLS system procedures.
•
Wear safety glasses.
•
Use extreme care with all heated materials.
•
Make sure that the room is well ventilated.
•
Keep containers closed when not in use.
•
Have a fully-grounded internal non-ignition vacuum
cleaner ready to use.
•
Have any equipment specified in the SDS ready to use.
5
Europe:
3D Systems GmbH
Guerickeweg 9 D-64291
Darmstadt, Germany
Phone: (+49) 6151 357-0
1.703.741.56100 - Chemtrec
(U.S.)
p/n 74-D001, Rev. A
Advertisement
Table of Contents
