Table of Contents
Advertisement
These must have selected before in the Satellite List.
The procedure is the same as for Single Satellite Search, except for the Satellites mentioned in the top line. All
those will be scanned one after the other.
7.1.5 Transponder Edit Options
Scanning by transponder (Manual Scan)
Select TP List in the Installation menu.
The transponder list is shown for the in the top line selected satellite.
Search
Options are:
FTA Only:
Scan Channel:
Network Search
7.1.5.1 Transponder List
Transponder Edit options
While in the TP list menu, you can use the coloured buttons to make changes.
The options below are now available.
Edit:
Add:
Delete transponder:
7.1.5.2 Satellite Edit options
While in the Satellite List menu.
Edit:
Add:
Delete:
To Delete a Satellite, select the Satellite from the list and press BLUE. Confirm the popup pop-up screen.
Use the pq buttons to highlight the transponder you want to scan and press
OK or BLUE for Search. A window with scanning settings will be displayed.
After configuring the settings press OK to start the scanning of the highlighted
transponder. When the scan process has been completed, all new found channels
will be added to the end of the channel list.
Press t u to select No to search for (scrambled and free) channels or {Yes to search
for Free to Air channels only.
NOTE: Scrambled channels can not be watched with this receiver.
Press t u to select TV+Radio, TV Channel or Radio
Use t u to select Yes or No. Some providers use more than one transponder to
transmit their Pay-TV programmes. Select Yes and one of those transponders and
it will find the corresponding transponders as well. Note: This is only applicable for
scrambled channels, which can not be seen with this receiver.
Press RED to edit the highlighted transponder. In the pop-up banner, change the
transponder´s parameters by using the pq t u and numeric buttons. Confirm
changes with OK or cancel with .
Press to add a new transponder. In the pop-up banner, enter the transponder´s
parameters by using the pq t u and the numeric buttons. Confirm the settings
with OK or cancel with . An existing TP cannot be stored again under the same
satellite. A pop-up message will inform you if the transponder already exists in the
list.
Press YELLOW to delete the highlighted transponder. Select Yes and press OK to
confirm or
to cancel.
Press RED to edit the focused satellite.
Edit the Satellite name and/or position. Use the numeric buttons to enter characters.
Confirm with YELLOW.
Press GREEN to add a new satellite.
Use the numeric buttons to enter characters for a new Satellite's name and position.
Confirm with YELLOW.
To Delete a Satellite, select the Satellite from the list and press BLUE. Confirm the
popup pop-up screen.
21
Advertisement
Table of Contents
