Only For Mvs Setups: Configuring The Main Station And Support Stations - Webasto DVS300 Operation & Maintenance Manual

Intelligent Fast-Charging System
4.2 – Only for MVS Setups: Configuring the Main Station and Support Stations.
The MVS Intelligent Fast-Charging System is very flexible. It requires each new installation to be configured for
the total number of power stations in the system.
1. Install the system.
2. Set the maximum port current configuration for each of the power stations. Each power station contains
a control board that is mounted on the inside surface of the door (Figure 4).
Control Board
3. Remove the three Phillips screws on the right-hand side of the power station door to open the door.
31504-03-0101
GSE O&M for DVS300 / 330 / 330 IP55 / 400 and MVS330/400
DIP Switch Bank
Figure 4 – Power Station Control Board Location
16 Webasto Charging Systems, Inc.