Intelligent Fast-Charging System
Procedure for Properly Seating an Incorrectly Seated Pin.
1. Remove the two retaining roll pins from the SBX housing.
2. Pull the red and black auxiliary housings from the SBX housing.
3. Remove the incorrectly seated pin from the auxiliary housing.
4. Rework the pin so that the tongue of the pin is in line with the pin body or at a slight downward angle.
(Figure 12 shows the CORRECT alignment. Figure 13 shows the INCORRECT alignment).
Body
Body
5. Insert the pin into the red and black auxiliary housing.
NOTE
6. Re-assemble the connector assemblies and test.
31504-03-0101
GSE O&M for DVS300 / 330 / 330 IP55 / 400 and MVS330/400
Tongue
Tongue
An audible click can be heard when the pin fully engages. Pull on the wire
to make certain that the pin is properly seated.
Figure 12 – Correct PIN Alignment
Figure 13 – Incorrect PIN Alignment
26
Webasto Charging Systems, Inc.