Adjusting The Traction Drive For Neutral - Toro Groundsmaster 7210 Operator's Manual

Figure 66
1. Neutral position
7. If adjustment is needed, loosen the nut and jam
nut against the yoke
8. Applying slight rearward pressure on the motion
control lever, turn the head of the adjustment
bolt in the appropriate direction until the control
lever is centered in the neutral lock position
(Figure 65).
Note:
Keeping rearward pressure on the lever
will keep the pin at the end of the slot and allow
the adjustment bolt to move the lever to the
appropriate position.
9. Tighten the nut and jam nut
10. Repeat steps 4 through
lever.
11. Install the front panel.
Adjusting the Traction
Drive for Neutral
This adjustment must be made with drive wheels
turning.
DANGER
Mechanical or hydraulic jacks may fail to
support the machine and cause a serious
injury.
• Use jack stands when supporting the
machine.
• Do not use hydraulic jacks.
2. Neutral locked position
(Figure 65).
(Figure 65).
9 for the other control
WARNING
The engine must be running to perform this
adjustment. Contact with moving parts or hot
surfaces may cause personal injury.
Keep hands, feet, face, clothing, and other
body parts away from rotating parts, muffler,
and other hot surfaces.
1. Raise the frame onto stable jack stands so that
the drive wheels can rotate freely.
2. Slide seat forward, unlatch it, and swing it up
and forward.
3. Disconnect the electrical connector from the
g004918
seat safety switch.
4. Temporarily install a jumper wire across
terminals in the wiring harness connector.
5. Start the engine, ensure that the throttle lever is
midway between the Fast and Slow positions,
and release the parking brake.
Note:
The motion control levers must be in
the neutral locked position while making any
adjustments.
6. Adjust the pump rod length on one side by
rotating the hex shaft, in the appropriate
direction, until the corresponding wheel is still or
slightly creeping in reverse
49
(Figure 67).