Figure 4
1. Side bracket
2. Curved washer, 3/8 inch
3. Bolt, 3/8 x 1-1/2 inch
9. Install the bagger mounting bracket to the rear
frame of the machine (Figure 5).
10. In the top two holes, install 2 bolts (3/8 x
1-3/4 inches), 2 round spacers, and 2 flange
nuts (3/8 inch).
11. In the bottom two holes, install 2 bolts (3/8
x 1-1/4 inches) and a 2 flange nuts (3/8
inch)(Figure 5).
Figure 5
1. Bagger mounting bracket
2. Bolt, 3/8 x 1-1/4 inch
3. Flange nut, 3/8 inch
4. Flange nut, 3/8 inch
5. ROPS
4. Bumper
5. Round spacer
6. Bolt, 3/8 x 1-3/4 inch
Step
2
Tightening all Mounting
Bolts
No Parts Required
Procedure
The following steps are the correct sequence to
tighten the side brackets and the bagger mounting
bracket.
All 3/8 inch mounting bolts need to be torqued to
35 ft-lb (48 N⋅m).
1. Tighten the bagger mounting bracket to the
rear frame first (Figure 5).
2. Tighten the bagger mounting bracket to the
side brackets (Figure 3).
3. Tighten the bracket stiffeners to both the
side plates and the bagger mounting bracket
(Figure 3).
4. Tighten the side brackets to the side of the
mower (Figure 4).
Step
3
Installing the Bagger Drive
Pulley
Parts needed for this step:
1
Bagger drive pulley
3
Pulley spacer
4
Bolt, (3/8 x 1-3/4 inches)
4
Flange nut, (3/8 inch)
Procedure
1. Remove the mower belt from the gearbox
pulley assembly (Figure 6).
2. Remove the 2 set screws, square key, and
gearbox pulley from the gearbox.
8