Changing The Hydraulic Oil And Filter - Toro Groundsmaster 7210 Operator's Manual

Figure 72
1. Dipstick
6. Remove the dipstick and wipe it with a clean rag
(Figure 72).
7. Place the dipstick into the filler neck; then
remove it and check level of fluid
Note:
If level is not within notched area of the
dipstick, add enough high quality hydraulic fluid
to raise level to within the notched area. Do not
overfill.
8. Replace the dipstick and thread the fill cap
finger-tight onto filler neck.
9. Check all hoses and fittings for leaks.
g004494
2. Fill cap
(Figure 72).
Changing the Hydraulic Oil
And Filter
Service Interval: After the first 200 hours
Every 800 hours
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set the
parking brake.
2. Move the throttle lever to the Slow position,
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Place a large pan under the hydraulic reservoir
and transmission case and remove the plugs,
draining all of the hydraulic fluid
1. Hydraulic reservoir drain
plug
2. Filter
4. Clean the area around the hydraulic oil filter and
remove it (Figure
5. Immediately install a new hydraulic oil filter.
6. Install the hydraulic reservoir and transmission
case drain plugs.
7. Fill the reservoir to the proper level
(approximately 6 quarts); refer to Checking the
Hydraulic System.
8. Start the engine and check for oil leaks. Allow
the engine to run for about five minutes, then
shut it off.
9. After 2 minutes, check the level of the hydraulic
fluid; refer to Checking the Hydraulic System.
53
(Figure
Figure 73
3. Transmission case drain
plug
73).
73).
g004652