Attachment Power Lift
The attachment power lift (Fig. 19) is used to raise
and lower attachments.
Raising Attachments
1.
Start the engine, refer to; Starting and Stopping
the Engine; in tractor Operator's Manual.
2.
Pull the lift lever in the "UP" direction to raise
the attachment lift (Fig. 19). This will lift and
hold the attachment in the up, or raised position.
Lowering Attachments
1.
Start the engine, refer to; Starting and Stopping
the Engine; in tractor Operator's Manual.
2.
Push the lift lever in the "DOWN" direction to
lower the attachment lift (Fig. 19). This will
lower the attachment lift.
2
1
Figure 19
1. Lift lever UP
m–2317
2. Lift lever DOWN
Adjusting Height-of-Cut
The rear gauge wheels are adjusted in different hole
location for 1-1/2–3-1/2" (4–9 cm) height-of-cut.
1.
Pull height-of-cut lever out to disengage from
quadrant. Adjust height-of-cut to the desired
level. Release lever inward to lock into quadrant
(Fig. 20).
1
4
Figure 20
1. Height-of-cut lever
2. Quadrant
Operation
3
2
m–2827
3. Low
4. High
11