Maintenance; Recommended Maintenance Schedule(S) - Toro Groundsmaster 7210 Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
Looking for an Electrical Schematic or
Hydraulic Schematic for your machine? Download a
free copy of the schematic by visiting www.Toro.com

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 200 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 800 hours
Every 1,500 hours
Every 6,000 hours
Every 2 years
Important:
Refer to your Engine Operator's Manual for additional maintenance procedures. A detailed
Service Manual is also available for purchase from your Authorized Toro Distributor.
Maintenance Procedure
• Change the hydraulic oil and filter.
• Test the safety system.
• Check the engine-oil level.
• Check the engine coolant level.
• Clean the radiator with compressed air (do not use water).
• Check the hydraulic fluid level.
• Grease the bearing and bushing grease fittings.
• Check battery cable connections.
• Check the alternator belt tension.
• Inspect cooling system hoses and seals. Replace them if cracked or torn.
• Change the engine oil and filter.
• Service the air cleaner.
• Replace the fuel filter canister for the water separator.
• Drain water or other contaminants from the water separator.
• Replace the engine fuel filter.
• Check the fuel lines and connections.
• Change the hydraulic oil and filter.
• Inspect engine valve clearance. Refer to your Engine Operator's Manual.
• Replace moving hoses.
• Disassemble, clean, and assemble the soot filter of the DPF. or clean the soot
filter if engine faults
SPN
in the InfoCenter.
• Drain and clean the fuel tank.
• Flush and replace cooling system fluid.
and searching for your machine from the Manuals link
on the home page.
3720 16, 3720
FMI SPN FMI
36
0, or 3720 16 display
SPN FMI