Toro Groundsmaster 7210 Operator's Manual page 16

Service
Menu Item
Hours
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
* Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced."
Titles will be in the selected language, but menu items
are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There is 1 operating configuration setting that is
adjustable within the Service Menu of the InfoCenter:
Regeneration request—this setting is in the Protected
Menu. Refer to Diesel Particulate Filter Regeneration
(page 23).
Description
Lists the total number of hours
that the machine, engine and
fan have been on, as well
as the number of hours the
machine has been transported
and has overheated.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the
code, contact your Authorized Toro Distributor for
assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit
(Figure 10B and
until the last digit is entered and press the right
button once more.
16
M , use the center button to
ENU
M and press the
ETTINGS ENU
9).
Figure 9
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 10A).
Figure 10
Figure 10C). Repeat this step
g028523
g028522