Brake Maintenance; Adjusting The Parking Brake Interlock Switch - Toro Groundsmaster 7210 Operator's Manual

Brake Maintenance

Adjusting the Parking
Brake Interlock Switch
1. Stop the machine, move the deck lift switch fully
into the neutral-locked position, set the parking
brake, and remove the ignition key.
2. Remove the bolts securing the front panel and
remove the panel
2
1
Figure 59
1. Bolts
2. Control panel
3. Loosen the 2 jam nuts securing the parking
brake interlock switch to the mounting bracket.
Figure 60
1. Brake-shaft sensor
2. Jam nuts
(Figure 59).
G020875
3. Parking-brake-interlock
switch
4. 3.9 mm (5/32 inch )
4. Move the switch up or down on the bracket until
the distance between the brake shaft sensor
and the switch plunger is 3.9 mm (5/32 inch)
(Figure 60).
Note:
Make sure that the brake-shaft sensor
does not contact the switch plunger.
5. Secure the switch jam nuts.
6. Test the adjustment as follows:
A. Ensure that the parking brake is engaged
and you are not sitting on the seat, then
start the engine.
B. Move the control levers out of the neutral
locked position.
The engine should stop. If not, recheck the
adjustment you made to the switch.
7. Install the front panel.
g020875
g012074
46