Operating The Parking Brake; Starting And Stopping The Engine - Toro Groundsmaster 7210 Operator's Manual

Operating the Parking
Brake
Always set the parking brake when you stop the
machine or leave it unattended.
Setting the Parking Brake
1. Move the motion control levers
to the neutral locked position.
2. Pull up and back on the parking brake lever to
set the parking brake
Note:
The parking-brake lever should stay
firmly in the engaged position.
Figure 13
1. Parking-brake lever
WARNING
The parking brake may not hold the
machine parked on a slope and could
cause personal injury or property
damage.
Do not park the machine on slopes
unless the wheels are chocked or
blocked.
(Figure 17) out
(Figure 13).
1
G020868
g020868
Releasing the Parking Brake
Push forward and down on the parking brake lever to
release the parking brake
1
1. Parking-brake lever
Starting and Stopping the
Engine
Starting the Engine
1. Raise the roll bar up and lock it into place, sit on
the seat, and fasten the seat belt.
2. Ensure that the motion controls are in the neutral
locked position.
3. Set the parking brake; refer to
Parking Brake (page
4. Move the PTO (power take-off) switch to the off
position (Figure
20
(Figure 14).
G020869
Figure 14
Setting the
20).
15).
g020869