Servicing The Diesel-Oxidation Catalyst (Doc) And The Soot Filter - Toro Groundsmaster 7210 Operator's Manual

6. Close the engine cover and secure it with the
latches.
Crankcase Oil Capacity
5.2 liters (5.5 qt) with the filter.
Changing the Engine Oil And Filter
Service Interval: Every 250 hours
Change the oil and filter every 250 hours.
1. Remove the engine oil drain plug
and let the oil flow into a drain pan. When all the
oil is drained, install the drain plug.
2
Figure 51
1. Engine oil drain plug
2. Remove the oil filter
coat of clean oil to the new filter seal before
screwing it on. Do not overtighten.
3. Add oil to the crankcase; refer to Checking the
Engine Oil.
(Figure
g021890
1
2. Oil filter
(Figure 51). Apply a light
Servicing the
Diesel-Oxidation Catalyst
(DOC) and the Soot Filter
Service Interval: Every 6,000 hours or clean the soot
•
If advisory message
InfoCenter, the DPF is nearing the recommended
point for servicing the diesel-oxidation catalyst and
the soot filter.
51)
•
If engine faults
CHECK ENGINE SPN
3720
SPN
display in the InfoCenter, clean the soot filter using
the steps that follow:
g021890
1. Refer to the Engine section in the Service
Manual for information on disassembling and
assembling the diesel-oxidation catalyst and
the soot filter of the DPF.
2. Refer to your Authorized Toro Distributor for
diesel-oxidation catalyst and the soot filter
replacement parts or service.
3. Contact your Authorized Toro Distributor to
have them reset the engine ECU after you
install a clean DPF.
41
filter if engine faults
16, 3720 0, or
SPN FMI
16 display in the InfoCenter.
179 displays in the
ADVISORY
Figure 52
CHECK ENGINE SPN
3720 0, or
FMI
16in the InfoCenter
FMI
Figure 53
3720
SPN FMI
3720
SPN FMI
g213865
3251 0,
FMI
CHECK ENGINE
(Figure 53)
g214715
g213864
g213863