Adjusting The Maximum Ground Speed - Toro Groundsmaster 7210 Operator's Manual

Figure 67
1. Right pump rod
2. Left pump rod
3. Ball joint
4. Bolt
7. Move the motion control lever forward and
reverse, then back to neutral. The wheel must
stop turning or slightly creep in reverse.
8. Move the throttle lever to the Fast position.
Make sure that the wheel remains stopped or
slightly creeps in reverse; adjust it if necessary.
9. Repeat steps 6 through
the machine.
10. Tighten the jam nuts at the ball joints
11. Move the throttle lever to the Slow position and
stop the engine.
12. Remove the jumper wire from the wire harness
connector and plug the connector into the seat
switch.
g004488
5. Jam Nut
6. Hex shaft
7. Ball joint
8 for the other side of
(Figure 65).
WARNING
Electrical system will not perform proper
safety shut off with jumper wire installed.
• Remove jumper wire from wire
harness connector and plug
connector into seat switch when
adjustment is completed.
• Never operate this unit with jumper
installed and seat switch bypassed.
13. Lower the seat into position.
14. Remove the jack stands.
Adjusting the Maximum
Ground Speed
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set the
parking brake.
2. Move the throttle lever to the Slow position,
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Remove the bolts securing the front panel and
remove the panel
2
1
1. Bolts
2. Control panel
4. Loosen the jam nut on the stop bolt for one of
the control levers
50
(Figure 68).
G020875
Figure 68
(Figure 69).
g020875