Adjusting The Control Lever Neutral Return - Toro Groundsmaster 7210 Operator's Manual

Figure 63
1. Control lever
2. Neutral interlock switch
4. Holding the control lever against the frame,
move the switch toward the lever until the
distance between lever and switch body is 0.4 to
1 mm (0.015 to 0.045 inch )
5. Secure the switch.
6. Repeat steps 3 to
7. Install the front panel.
Adjusting the Control Lever
Neutral Return
If the motion control levers do not align with the
neutral slots when released from the reverse drive
position, adjustment is required. Adjust each lever,
spring, and rod separately.
1. Disengage the PTO, move the control lever to
the neutral locked position, and set the parking
brake.
2. Move the throttle lever to the Slow position,
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Remove the bolts securing the front panel and
remove the panel
3. Screws
4. 0.4 to 1 mm (0.015 to
0.045 inch )
(Figure 63).
5 for the other lever.
(Figure 64).
1
1. Bolts
g004763
2. Control panel
4. Move the control lever to the neutral position but
not locked
5. Pull the lever back until the clevis pin (on an
arm above the pivot shaft) contacts the end of
the slot (just beginning to put pressure on the
spring) (Figure
1. Clevis pin
2. Slot
3. Jam nuts
6. Check where the control lever is relative to notch
in console
Note:
It should be centered allowing lever to
pivot outward to the neutral lock position.
48
2
G020875
Figure 64
(Figure 66).
65).
Figure 65
4. Adjustment bolt
5. Yoke
(Figure 66).
g020875
g004651