Driving The Machine - Toro Groundsmaster 7210 Operator's Manual

3
Figure 15
1. Ignition switch
2. Throttle control
5. Turn the ignition key clockwise to the Run
position (Figure 16).
Figure 16
1. Ignition switch
2. Off
6. After the glow plug indicator light dims, turn the
key to the Start position. When the engine starts
release the key.
Important:
Use starting cycles of no
more than 15 seconds per minute to avoid
overheating the starter motor.
Note:
Additional starting cycles may be
required when starting the engine for the first
time after the fuel system has been completely
drained.
Important:
When the engine is started for
the first time, or after an engine oil change,
or an overhaul of the engine, transmission,
or wheel motor, operate the machine with
1
2
g022121
g022121
3. Power take off switch
(PTO)
g004917
3. Run
4. Start
the throttle lever in the Slow position in both
the forward and reverse directions for 1 to
2 minutes. Also operate the lift lever and
PTO lever to ensure proper operation of all
parts. Then shut the engine off and check
fluid levels, check for oil leaks, loose parts,
and any other noticeable malfunctions.
CAUTION
Shut the engine off and wait for all
moving parts to stop before checking
for oil leaks, loose parts, or other
malfunctions.
Stopping the Engine
1. Disengage the PTO, move the motion control
levers to the neutral locked position, set the
parking brake, and move the throttle lever to the
Slow position.
2. Turn the ignition key to the Off position
16). Wait for all moving parts to stop before
leaving the operating position.
3. Remove the key before transporting or storing
machine.
Important:
Make sure to remove the key as
the fuel pump or accessories may run and
cause the battery to lose charge.
CAUTION
Children or bystanders may be injured
if they move or attempt to operate the
tractor while it is unattended.
Always remove the ignition key and
set the parking brake when leaving the
machine unattended, even if just for a
few minutes.

Driving the Machine

The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the Fast position for best
performance. Always operate in the Fast throttle
position when mowing.
CAUTION
The machine can turn very rapidly. You may
lose control of it and cause personal injury or
damage to machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
21
(Figure