Checking The Chain, Rear Sprocket, Engine Sprocket, And Chain Guide - GAS GAS SM 700 2023 Owner's Manual

11.25

Checking the chain, rear sprocket, engine sprocket, and chain guide

Main work
–
1
Loosen nut
–
2
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
right.
Guideline
Chain tension
Turn the adjusting screws
markings on the left and right chain adjusters
position relative to the reference marks
then correctly aligned.
Info
The top chain section must be taut.
Chain wear is not always even. Repeat this measurement at
different chain positions.
–
2
Tighten nuts
–
Make sure that chain adjusters
V02762-10
3
screws .
–
1
Tighten nut
Guideline
Nut, rear wheel spindle
Preparatory work
–
Raise the motorcycle with the rear lifting gear. (
Main work
–
Shift the transmission into neutral.
–
Check the chain, rear sprocket, and engine sprocket for wear.
» If the chain, rear sprocket or engine sprocket is worn:
–
Change the drivetrain kit.
100132-10
SERVICE WORK ON THE CHASSIS 11
.
.
5 mm (0.2 in)
3
on the left and right so that the
C
. The rear wheel is
.
4
are fitted correctly on adjusting
.
M25x1.5 90 Nm (66.4 lbf ft)
Info
The engine sprocket, rear sprocket, and chain
should always be replaced together.
3
left and
4
are in the same
p. 46)
57