Interrupted Milling Process; Inaccurate Milling Result; Return - Zirkon zahn M2 MILLING UNIT COMFORT LINE Operation And Maintenance Manual

CHAPTER
REPAIRS AND TROUBLESHOOTING

Interrupted milling process

- Check whether the front plate is closed.
- Check power supply => machine switches off in case of power failure and must be
started and referenced manually again.
- Check compressed air connection.
- Consider error message of the software.

Inaccurate milling result

-
- Calibrate the milling unit: select "calibration" in the software Zirkonzahn.Fräsen and follow
the instructions step by step. Important: The orbit has to be absolutely clean and free of dust
and dirt. Calibration is carried out using an electrical measurement sensor or zero point sensor
(included in the scope of delivery).
- Clean spindle and collet chuck.

RETURN

If a defect is detected, consult Zirkonzahn in order to discuss further steps.
If return shipment is required, always use the original packaging.
Observe indication on transport packaging (fragile, this side up).
Use suitable packaging for possible return of individual device components!
56
ZIRKONZAHN – OPERATION AND MAINTENANCE M2 MILLING UNIT COMFORT LINE – VERSION: 19/05/2021