Zirkon zahn M2 MILLING UNIT COMFORT LINE Operation And Maintenance Manual page 39

4
5
6
7
ZIRKONZAHN – OPERATION AND MAINTENANCE M2 MILLING UNIT COMFORT LINE – VERSION: 19/05/2021
If the Cleaning Kit is mounted on the left-hand side,
connect the supplied hose to the upper connection of the
Cleaning Kit and the other end to the rear of the milling unit.
If the Cleaning Kit is mounted on the right-hand side,
connect the supplied hose to the lower connection of the
Cleaning Kit and the other end to the rear of the milling unit.
Remove the connector located on the rear of the
milling unit.
ADVICE: To remove it, press the blue edge while
extracting the connector.
Attach the green and yellow hoses of the Cleaning Kit to
the rear of the milling unit.
The hoses can be shortened with scissors, if necessary.
Two Cleaning Buckets are included in the scope of
delivery of the milling unit. One of them is equipped with
the necessary connections for the milling unit hoses.
CHAPTER
FIRST START-UP
39