Cleaning Intervals; Daily Or After Each Use; Weekly; Clean Milling Chamber - Zirkon zahn M2 MILLING UNIT COMFORT LINE Operation And Maintenance Manual

CHAPTER
CLEANING

CLEANING INTERVALS

The following cleaning intervals must be observed for the machine to operate properly (in addition
to maintenance - maintenance plan is available as a separate document):

Daily or after each use

- Clean milling chamber.

- Clean orbit.

Weekly

- Clean spindle and collet chuck.
- Clean milling chamber with the Cleaning Kit.
CLEAN MILLING CHAMBER
The milling chamber of the machine must be cleaned after each use. Before starting a new milling
job, the milling chamber should be checked for impurities such as dust deposits and, if necessary,
cleaned again before starting.
Before cleaning, any workpieces that may still be present must be removed from the milling
chamber.
The use of a suitable vacuum cleaner (follow manufacturer's instructions) is recommended.
All areas to be cleaned are easily visible and easily accessible with standard vacuum cleaner
attachments.
For cleaning, the cleaning positions listed in the milling software must be selected one after
the other. Open the safety glass only after the orbit has come to a standstill, as indicated by the
green interior lighting, otherwise the machine will malfunction and switch off the orbit (safety
mechanism).
Alternatively, the Cleaning Kit can be used to clean the milling chamber.

CLEANING OF THE ORBIT WITH WET PROCESSING (WITH ORBIT CLEANING LIQUID)

- Clean the orbit with the Orbit Cleaning Liquid as shown in the manual.
- Safety regulations of the product Orbit Cleaning Liquid must be observed!
48
ZIRKONZAHN – OPERATION AND MAINTENANCE M2 MILLING UNIT COMFORT LINE – VERSION: 19/05/2021