Other Symbols; Residual Risks And Safety Regulations - Zirkon zahn M2 MILLING UNIT COMFORT LINE Operation And Maintenance Manual

CHAPTER
SAFETY AND RESIDUAL RISKS
Higher noise emissions can occur
during elaboration (e.g. when tools
are worn out).
High empty weight of the milling
unit: Risk of contusions (especially
during transport and installation).
Dust and sharp tools (milling burs):
Cuts and contusions during operation.
Aggressive cleaning agents (orbit
cleaning): Danger of skin irritation.

Other symbols

Symbol
General warnings that can lead to injuries if disregarded.
This symbol refers to particularly important text passages in the operation and
maintenance manual.
This symbol indicates the necessity to document work processes.

RESIDUAL RISKS AND SAFETY REGULATIONS

Read and follow the safety instructions in this operation and maintenance manual to avoid danger
In the event of equipment defects push the emergency shutdown switch and follow hazard
warnings.
The changing interior lighting is part of the safety concept and enables the closing
surveillance to be checked. If the lighting colour in the interior does not change
from green to another colour when the front plate is opened, there is a defect and
the milling unit could start unintentionally even when the front plate is open. Set the
device out of operation and contact the Zirkonzahn support team at the Zirkonzahn
headquarters in Gais (Tel. +39 0474 066 630 or e-mail: info@zirkonzahn.com).
18
ZIRKONZAHN – OPERATION AND MAINTENANCE M2 MILLING UNIT COMFORT LINE – VERSION: 19/05/2021
Wear suitable ear protection.
Wear suitable protective gloves and
also safety shoes when setting-up
and transporting.
Wear suitable chemical resistant
gloves.